KTM 2011 690 SMC AUS, Руководство по ремонту

Страница: 122 / 229

16 ENGINE
120
–
Mount and tighten screw
A
with the washer.
Guideline
Locking screw for bearing M5 6 Nm
(4.4 lbf ft) Loctite ® 243™
–
Press in the shaft seal ring of countershaft
2
and shift shaft
3
with the open side
facing inwards so that it is flush.
–
Mount and tighten the oil jet
1
.
Guideline
Oil jet, piston cooling M6x0.75 4 Nm
(3 lbf ft) Loctite ® 243™
–
Mount the dowels.
–
Blow compressed air through all oil channels and check that they are clear.
200155-10
–
Measure the spring length of the oil pressure regulator valve.
Oil pressure regulator valve - minimum
spring length 25.36 mm (0.9984 in)
» If the measured value does not equal the specified value:
–
Change the spring.
–
Check the piston valve for damage and wear.
» If there is damage or wear:
–
Replace the piston valve.
300093-10
–
Lubricate piston valve
9
and mount it with pressure spring
8
. Mount and tighten
screw plug
7
with the new seal ring.
Guideline
Oil pressure regulator valve plug M12x1.5 20 Nm
(14.8 lbf ft)
–
Position the membrane support plate
5
with membrane
6
. Mount and tighten the
screws.
Guideline
Screw, membrane fixation M3 2.5 Nm
(1.84 lbf ft) Loctite ® 243™
Info
The membrane support plate is curved and must point away from the mem-
brane.
An incorrectly installed membrane support plate results in loss of perfor-
mance and increased oil consumption or leaks.
Do not apply thread locker between the membrane and the membrane sup-
port plate since this would impair their function.
16.4.3 Work on the clutch cover
300097-10
–
Remove the shaft seal ring
1
of the crankshaft.
–
Press in a new shaft seal ring with the open side facing inward until it stops.
Info
Support the clutch cover sufficiently when pressing in.
–
Blow compressed air through the oil channel and check that it is clear.