Rivco VCC094, Быстрый старт

Страница: 1 / 5

VCC094
Victory Cross country and Tour Armrests
2010 and newer Models equipped with a Trunk
1. Unpack the armrests and familiarize yourself with the left and right side armrests and the instructions.
2. Remove the trunk liner if your model is so equipped.
3. Remove the upper backrest pad by removing the four 6MM Allen screws (photo (1A). Remove the lower
backrest pad by removing the three screws (photo 1B).
4. Locate the trunk lid light plug (photo 1C). Unplug the connector then push the wire and plug out through
the hole in the lid to the other side of the lid. Referring to photo (1D) remove the two 6mm Allen screws.
5. Remove the trunk lid lower tether cord bracket 6mm screws (photo1E) and close the lid.
6. Remove the eight 4mm wrench size Allen screws (photo 2A) from the lid hinge brackets and the nut
retainers from the underside of the lid. Remove the lid and set it aside.
7. Remove the two 4mm Allen screws from the speaker covers (photo 2B), remove the covers, and set them
aside.
8. Referring to photo (3A) (Allen wrenches shown inserted in openings for clarity) remove the upper 6mm and
lower 4mm Allen screws from both the left and right side. Referring to photo (1G) remove the four 6mmm
Allen screws). Unplug the speaker wires and set the speaker housings aside.
9. Starting on left side while supporting the hinge and support bracket below the hinge with one hand remove
the two 6mm Allen screws (photo 3B) and two 10mm wrench size bolts (photo 3C). Set the hinge and
support brackets aside. On the right side remove the same screws and bolts (photo 3B & 3C). Then
referring to photo (1F) remove the 2 remaining 6mm Allen screws securing the right hinge and support
bracket and set these aside also.
10. Locate the template sheet supplied. Cut out the left and right templates as shown in photo (4). Align and
tape them to the speaker housings as shown. Make the cut outs as shown using a coping, hack saw or
abrasive cut off wheel then finish any rough edges with a file. A perfect edge is not needed as this cut out
is almost unseen once installed.
11. The lower support brackets will not be reused as the armrest brackets replace these, so starting with the
left armrest on the left side of the trunk, hold the armrest up into place and loosely install the lower 6mm
screw first (1D) then the upper two 6mm screws (1E).
12. Locate one of the lid hinges, note that one side is flat and the other has a bend in it. Insert the flat side of
the hinge between the trunk and the armrest bracket also being sure the other half of the hinge pivots
upward. Align the screw holes and loosely install the two 6mm Allen screws (3B) and two 10mm bolts
(3C).
13. Using the left speaker housing, route the trunk lid wire behind the housing and exiting at the top near the
hinge bracket then reconnect the speaker wires. Loosely install the two 6mm screws inside the trunk (1G),
then the 4mm and 6mm screws (photo 3A). Tighten these four screws securely.