KTM 2011 690 SMC AUS, Руководство по ремонту

Страница: 185 / 229

24 SERVICE SCHEDULE
183
24.1 Service schedule
Every 30,000 km (18,641 mi) or every 4 years
Every 15,000 km (9,321 mi) or every 2 years
Every 7,500 km (4,660 mi) or annually
Once after 1,000 km (621.4 mi)
Check that the electrical equipment is functioning correctly.
○ ●
Read out the fault memory using the KTM diagnostics tool.
○ ●
Check the measured service values with the KTM diagnostics tool.
●
Change the engine oil and filter, clean the oil screens. ( p. 166)
○ ●
Check the front brake linings. ( p. 85)
○ ●
Check the rear brake linings. ( p. 88)
○ ●
Check the brake discs. ( p. 69)
○ ●
Check the brake lines for damage and leakage.
○ ●
Check the rear brake fluid level. ( p. 91)
○ ●
Check the free travel of the foot brake lever. ( p. 90)
○ ●
Lubricate the linkage of the rear wheel suspension.
●
Check that the shock absorber and fork are leak tight. If necessary and depending on use, service the fork and
shock absorber.
○ ●
Check the swingarm bearing.
●
Check the wheel bearing for play.
●
Check the tire condition. ( p. 68)
○ ●
Check the tire air pressure. ( p. 68)
○ ●
Check the spoke tension. ( p. 69)
○ ●
Check for rim run-out.
○ ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 75)
●
Check the chain tension. ( p. 74)
○ ●
Grease all moving parts (e.g. side stand, hand lever, chain, ...) and check for smooth operation.
○ ●
Clean the dust boots of the fork legs. ( p. 15)
●
Check the front brake fluid level. ( p. 86)
○ ●
Bleed the fork legs. ( p. 14)
●
Check the steering head bearing play. ( p. 27)
○ ●
Change the spark plug.
● ●
Check the valve clearance.
●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect rout-
ing.
● ●
Check the antifreeze and coolant level. ( p. 162)
○ ●
Check the cables for damage and routing without sharp bends.
●
Check that the throttle cables are undamaged, routed without sharp bends and set correctly.
○ ●
Change the air filter. Clean the air filter box.
●
Check the fuel pressure.
●
Check the CO adjustment with the KTM diagnostics tool.
●
Check/rectify the fluid level of the hydraulic clutch. ( p. 160)
●
Check the screws and nuts for tightness.
○ ●
Change the coolant.
●
Change the front brake fluid. ( p. 88)
● ●
Change the rear brake fluid. ( p. 92)
● ●
Check the clutch.
● ●
Check the headlight setting. ( p. 96)
○ ●
Check that the radiator fan is functioning properly.
○ ●
Final check: Check the vehicle for roadworthiness and take a test ride.
○ ●
Read out the fault memory using the KTM diagnostics tool after a test ride.
○ ●
Make the service entry in KTM DEALER.NET and in the service record.
○ ●