KTM 2011 690 SMC AUS, Руководство по ремонту

Страница: 98 / 229

15 LIGHTING SYSTEM, INSTRUMENTS
96
15.2 Checking the headlight setting
400726-10
–
Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically at a distance
A
in front of the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider, with luggage and a passenger if applicable, now sits down on the motor-
cycle.
–
Switch on the low beam.
–
Check the headlight setting.
For a ready-to-operate motorcycle with a rider, and with luggage and a passenger
if applicable, the light-dark boundary must lie exactly on the lower mark.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 96)
15.3 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 96)
800084-10
Main work
–
Turn adjusting screw
1
to adjust the headlight range.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (instructions on how to apply the mark: Checking the
headlight setting).
Info
Turn clockwise to increase the headlight range; turn counterclockwise to
reduce the headlight range.
If you have a heavy payload, you will need to correct the headlight range.
15.4 Removing the headlight mask with the headlight
Preparatory work
–
Switch off all power consumers and switch off the engine.
100296-11
Main work
–
Cover the fender with a cloth to protect it from damage.
–
Remove screws
1
on both sides.
–
Tip the headlight mask forward.
100294-10
–
Disconnect the connectors of turn signals
2
and headlight
3
.
–
Remove the headlight mask.