37
4.2.9
Laod Default
In this section, you can reset all the configurations of the switch to default setting. Click on
Reset
the system will then reset all configurations to default setting. The system will show
you popup message window after finishing this command. Default setting will work after
rebooting the switch.
Figure 4.2.9.1 The main screen of the Reset to Default
F
i
g
u
r
e
4.2.9.2 Popup alert screen to confirm the command. Click on
Yes
to start it.
Figure 4.2.9.3 Popup message screen to show you that have done the command. Click on
OK
to close the screen. Then please go to
Reboot
page to reboot the switch.
Click on
OK.
The system will then auto reboot the device.
Note: If you already configured the IP of your device to other IP address, when you use this
command by CLI and Web UI, our software will not reset the IP address to default IP. The
system will remain the IP address so that you can still connect the switch via the network.
4.2.10
System Reboot
System Reboot allows you to reboot the device. Some of the feature changes require you
to reboot the system. Click on
Reboot
to reboot your device.
Note:
Remember to click on
Save
button to save your settings. Otherwise, the settings you
made will be gone when the switch is powered off.
