49
This command can be used when connect the switch by 2-port LACP through not-direct
connected or shared media, like the Wireless AP or Hub. The end of the switch may not
directly detect the failure; the LACP Short Timeout can detect the LACP group failure
earlier within 3 seconds.
Aggregation Status
This page shows the status of port aggregation. Once the aggregation ports are negotiated
well, you will see following status.
Group ID:
Display Trunk 1 to Trunk 5 set up in Aggregation Setting.
Type: Static or LACP set up in Aggregation Setting.
Aggregated:
When LACP links well, you can see the member ports in “Aggregated
“column.
Individual:
When LACP is enabled, member ports of LACP group which are not connected
to correct LACP member ports will be displayed in the Individual column.
Link Down:
When LACP is enabled, member ports of LACP group which are not linked up
will be displayed in the Link Down column.
4.3.7
Command Lines for Port Configuration
Feature
Command Line
Port Control
Port Control – State Switch(config-if)# shutdown -> Disable port state
interface fastethernet1 is shutdown now.
Switch(config-if)# no shutdown -> Enable port state
interface fastethernet1 is up now.
Port Control – Auto
Negotiation
Switch(config-if)# auto-negotiation
Auto-negotiation of port 1 is enabled!
Port Control – Force
Speed/Duplex
Switch(config-if)# speed 100
set the speed mode ok!
Switch(config-if)# duplex full
set the duplex mode ok!
Port Control – Flow
Control
Switch(config-if)# flowcontrol on
Flowcontrol on for port 1 set ok!
Switch(config-if)# flowcontrol off