50
Flowcontrol off for port 1 set ok!
Port Status
Port Status
Switch# show interface fa1
Interface fastethernet1
Description : N/A
Administrative Status : Enable
Operating Status : Connected
Duplex : Auto (Full)
Speed : Auto (100)
MTU : 2000
Flow Control : off
Default Port VLAN ID: 1
Acceptable Frame Type : All
Auto Negotiation : Enable
Loopback Mode : None
STP Status: Forwarding
Default CoS Value for untagged packets is 0.
Medium mode is Copper.
Switch# show sfp ddm
show SFP DDM information
Port 17
Temperature:N/A
Tx power:N/A
Rx power:N/A
Port 18
Temperature:64.00 C <range :0.0-80.00>
Tx power:-6.0 dBm <range : -9.0 - -4.0>
Rx power:-30.0 dBm <range: -30.0 - -4.0>
Switch(config-if)# sfp
ddm Digital diagnostic and monitoring
eject Eject SFP
scan Scan SFP
Note: Administrative Status -> Port state of the port. Operating
status -> Current status of the port. Duplex -> Duplex mode of
the port. Speed -> Speed mode of the port. Flow control ->
Flow Control status of the port.
Rate Control
Rate Control –
Ingress or Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress
or Egress rule first; then assign the packet type and
bandwidth.
Rate Control -
Bandwidth
Switch(config-if)# rate-limit ingress bandwidth
<0-1000000> Limit in kilobits per second (FE: 0-100000,
GE: 0-1000000, 0 is no limit)
Switch(config-if)# rate-limit ingress bandwidth 800
Set the ingress rate limit 800Kbps for Port 1.
Storm Control
Strom Control – Rate Switch(config-if)# storm-control
broadcast Broadcast packets