10.27
Section 10
Reassembly
10
Install Muffler
1. Install the port liners (if equipped). Attach the
muffler and secure with the four hex flange nuts
onto the exhaust studs. See Figure 10-110. Torque
the hex flange nuts to
24.4 N·m (216 in. lb.)
.
2. Install any attaching hardware and brackets.
Torque M6 screws to
9.9 N·m (88 in. lb.),
and M8
screws to
24.4 N·m (216 in. lb.)
.
Figure 10-110. Installed Muffler.
3. Install spark arrestor (if used).
Install Oil Filter and Add Oil to Crankcase
1. Install the oil drain plugs. See Figure 10-111.
Torque the plugs to
21.4 N·m (15.7 ft. lb.)
.
NOTE
: Make sure that both oil drain plugs are
installed and torqued to the above
specifications to prevent oil leakage.
3. Apply a thin film of clean engine oil to the rubber
gasket on the oil filter and thread the filter onto
the adapter nipple. See Figure 10-112.
4. Hand tighten the filter until the rubber gasket
contacts the oil filter housing (not inner cup),
then tighten the filter an additional 3/4-1 turn.
See Figure 10-112.
Figure 10-111. Reinstall Oil Drain Plugs.
2. Install a new oil filter following the instructions
in Section 6.
Figure 10-112. Installing Oil Filter.
5. Add oil to bring the level up to the “F” mark.
Reinstall the dipstick and oil fill cap. See Figure
10-113.
Figure 10-113. Reinstall the Dipstick.
Oil Drain Plug Location (Starter Side Shown)
Flange Nuts (4)
