Juniper JUNOSE 11.2, Руководство по настройке

Страница: 91 / 772

host1(config-vc-class)# exit
•
Use the no version to disable F5 OAM CC verification and restore the default setting
for cell termination, end-to-end .
•
See oam cc.
oam-pvc
•
Use to enable generation of F5 OAM loopback cells on an ATM data PVC and, optionally,
enable F5 OAM VC integrity features on the circuit.
•
For detailed information about how to use this command, see “oam-pvc” on page 50.
•
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
•
Example
host1(config-vc-class)# oam-pvc manage 15
host1(config-vc-class)# exit
•
Use the no version to restore the default behavior, which disables F5 OAM VC integrity
on the router and restores the default value for loopback frequency, 10 seconds.
•
See oam-pvc.
oam retry
•
Use to configure F5 OAM VC integrity parameters on an ATM data PVC.
•
For detailed information about how to use this command, see “oam retry” on page 51.
•
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
•
Example
host1(config-vc-class)# oam retry 5 6 3
host1(config-vc-class)# exit
•
Use the no version to restore the default values for the up retry count (3 successive
loopback cell responses), down retry count (5 successive loopback cell responses),
and retry frequency (1 second).
•
See oam retry.
ubr
•
Use to configure the UBR service category on an ATM data PVC.
•
For detailed information about how to use this command, see “ubr” on page 46.
•
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
•
Example
host1(config-vc-class)# ubr 5000
host1(config-vc-class)# exit
59 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring ATM