Juniper JUNOSE 11.2, Руководство по настройке, Страница: 768 / 772

show interfaces commands
show interfaces fastEthernet..........................157, 187
show interfaces gigabitEthernet....................157, 187
show interfaces lag......................................................218
show interfaces lag members.................................218
show interfaces pos ...................................................367
show interfaces tenGigabitEthernet.............157, 187
show ip mac-validate command...................................462
show mpls cross-connects atm command................102
show ppp commands
show ppp interface ....................................................283
show ppp interface mlppp.......................................332
show ppp interface summary.......................283, 332
show pppoe commands
show pppoe interface............................421, 602, 693
show pppoe interface lockout-time.........603, 694
show pppoe interface summary............................423
show pppoe subinterface...................428, 604, 695
show pppoe subinterface summary....................428
show profile commands
show profile .............................................430, 604, 695
show radius commands
show radius override..................................................433
show radius remote-circuit-id-delimiter............434
show radius remote-circuit-id-format................434
show subscriber-policy command................................487
show vlan commands
show vlan bulk-config...............................................695
show vlan subinterface..........................460, 611, 703
show vlan subinterface command.................................192
shutdown command............................................................115
dynamic interfaces..........................................645, 668
Frame Relay.....................................................................114
POS..................................................................................364
shutting down interfaces
dynamic ATM 1483.....................................................645
dynamic VLAN.............................................................668
Frame Relay.....................................................................114
POS..................................................................................364
Simple Network Management Protocol. See SNMP
link status processing
SLARP (Serial Line Address Resolution
Protocol).............................................................................503
Keep-Alive protocol...................................................503
keepalive interval........................................................506
overview..........................................................................503
See also Cisco HDLC
slow protocols
bandwidth requirements..........................................226
definition of
rate of transmission of OAM PDUs..............226
multicast address of
and destination MAC address of remote
entities.................................................................231
OAM messages and....................................................226
SMs (Service modules)
MLPPP features...........................................................304
SNAP (subnetwork attachment point)........................167
SNMP (Simple Network Management Protocol)
link status processing.......................................................115
snmp trap frame-relay link-status command............115
SONET (Synchronous Optical Network)............28, 359
source, clock
ATM interfaces.................................................................27
SRP Ethernet interfaces
support for link-fault management......................237
SSN LCP (short sequence number Link Control
Protocol) configuration option....................................301
stacked virtual local area networks. See S-VLANs
stateful SRP switchover
and atm atm1483 subscriber command............632
and subscriber command......................519, 552, 557
Ethernet link-fault management
dependence on completion time..................237
effect on OAM settings.....................................237
of more than 2 seconds....................................237
recommendation for high and low
threshold configuration................................237
recommendation for PDU loss threshold
setting.................................................................237
static interfaces............................................................512, 619
configuring Multiclass MLPPP................................353
creating in VC subranges...............................629, 650
creating in VLAN subranges....................................679
static mapping, and NBMA interfaces............................38
subinterfaces
ATM 1483, dynamic....................................................624
ATM 1483, static................................................................3
Frame Relay, monitoring............................................127
MLFR, monitoring.........................................................148
VLAN, dynamic.............................................................653
subnet mask
assigning to PPP interface........................................273
subnetwork attachment point. See SNAP
subranges, VC. See VC subranges
subscriber command...........514, 519, 552, 556, 591, 593
Copyright © 2010, Juniper Networks, Inc. 736
JunosE 11.2.x Link Layer Configuration Guide