Juniper JUNOSE 11.2, Руководство по настройке

Страница: 305 / 772

•
To specify a POS interface for E120 and E320 routers, use the slot / adapter / port format.
•
slot —Number of the chassis slot
•
adapter —Identifier for the IOA within the E320 chassis, either 0 or 1, where:
•
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
•
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
•
port —Port number on the IOA
•
For more information about modules that support POS interfaces, see chapter
Configuring Unchannelized OCx/STMx Interfaces in JunosE Physical Layer Configuration
Guide .
•
Examples
host1(config-if)# interface pos 0/1
host1(config-if)# interface pos 5/0/0
•
Use the no version to remove the POS interface.
•
See interface pos.
interface serial
Use to specify a serial interface in the slot/port:channel/subchannel format by selecting
a previously configured physical interface on which you want to configure PPP.
•
•
slot —Refers to a router chassis slot.
•
port —Refers to a CT3, T3, or E3 module I/O port.
•
channel —Refers to a T1 (DS1) channel.
•
subchannel —Represents a set of DS0 subchannels.
•
Example
host1(config)# interface serial 3/0:2/5
•
Use the no version to disable or remove the subinterface or the logical interface.
•
See interface serial.
ip address
•
Use to assign an IP address and subnet mask for a PPP interface.
•
Example
host1(config-if)# ip address 192.168.22.10 255.255.255.0
•
Use the no version to remove an IP address or disable IP processing.
•
See ip address.
273 Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Configuring Point-to-Point Protocol