Juniper JUNOSE 11.2, Руководство по настройке

Страница: 322 / 772

•
request-retry—Maximum number of authentication requests retried before returning
a deny
•
request-timeout—Maximum time, in seconds, to wait for an authentication request
packet
•
If the operational status is down for a specific interface, one of the following
termination reasons might appear in parentheses:
•
administrative disable—Interface has been administratively disabled, which means
that the
ppp shutdown command is in effect. This applies to an interface, IPCP,
IPv6CP, OSINLCP, and MPLS.
•
administrative logout—Interface has been administratively logged out, which
means that the
logout subscriber command has been issued. This applies to an
interface only.
•
no upper interface—No upper layer is configured. This applies to an interface only.
•
authentication failure—Authentication is required and has failed. This applies to
an interface only.
•
no local xxx—local option, xxx, is required and could not be negotiated (for example,
IP address). This applies to an interface, IPCP, IPv6CP, OSINLCP, and MPLS.
•
no peer xxx—Remote peer option, xxx, is required and could not be negotiated (for
example, authentication). This applies to an interface, IPCP, IPv6CP, OSINLCP,
and MPLS.
•
keepalive drop count exceeded—Keepalive drop count has been exceeded. This
applies to an interface only.
•
session timeout—Session timeout period has expired. This applies to an interface
only.
•
inactivity timeout—Inactivity timeout period has expired. This applies to an interface
only.
•
address lease expired—Address lease period has expired. This applies to an
interface only.
•
not configured—Protocol is not configured on the interface. This applies to IPCP,
IPv6CP, OSINLCP, and MPLS.
•
link down—Link is down and the protocol is not operationally up. This applies to
IPCP, IPv6CP, OSINLCP, and MPLS.
•
lower layer down—Lower protocol layer is down. This applies to an interface only.
•
max configure exceeded—Maximum number of configure requests was exceeded
while negotiations were in progress. This means that there was no response from
Copyright © 2010, Juniper Networks, Inc. 290
JunosE 11.2.x Link Layer Configuration Guide