Juniper JUNOSE 11.2, Руководство по настройке

Страница: 65 / 772

•
Example 1—Deletes all F4 OAM circuits on the interface
host1(config-if)# no atm oam
•
Example 2—Deletes all F4 segment OAM circuits on the interface
host1(config-if)# no atm oam segment
•
Example 3—Deletes the F4 end-to-end OAM circuit on VPI 8
host1(config-if)# no atm oam 8 end-loopback
•
See atm oam.
Configuring F5 OAM
F5 OAM flows run over existing PVCs. The ATM interface does not support sending F5
segment loopback cells, but it does respond to F5 segment loopback cells that it receives.
NOTE: You cannot enable both loopback cells and CC cells at the same time.
To set up F5 OAM:
1.
To enable VC integrity, which causes the ATM interface to periodically send F5
end-to-end loopback cells over a VC, use the
oam keyword with the atm pvc
command.
You can include the frequency (in seconds) with which the router sends F5 end-to-end
loopback cells.
host1(config-if)# atm pvc 98 38 22 aal5snap oam 300
2.
(Optional) To enable CC cell flows on a circuit, use the cc keyword with the atm pvc
command. You can enable cell flows on a segment or end-to-end basis, and you
can enable the PVC as a sink, source, or both a sink and a source.
host1(config-if)# atm pvc 50 0 50 aal5snap oam cc end-to-end sink
When you issue the appropriate shutdown command to change the administrative status
of the corresponding ATM interface, ATM AAL5 interface, or ATM 1483 subinterface from
enabled to disabled, the router automatically disables all F5 OAM services configured
on the associated VC. For more information, see “Automatic Disabling of F5 OAM Services”
on page 19.
atm pvc
•
Use the atm pvc command with the oam keyword to set up the PVC to periodically
transmit F5 end-to-end loopback cells over a VC.
•
You can use the oam keyword only if you specify one of the following encapsulation
types:
•
aal5snap
•
aal5mux ip
33 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring ATM