Juniper JUNOSE 11.2, Руководство по настройке

Страница: 574 / 772

•
Use to select an ATM interface or ATM 1483 subinterface.
•
For information about specifying the ATM interface or subinterface, see “interface atm”
on page 529.
•
Examples
host1(config)# interface atm 5/0.1
host1(config)# interface atm 4/0/2.1
•
Use the no version to remove the interface or subinterface.
•
See interface atm.
interface fastEthernet
•
Use to select a Fast Ethernet interface.
•
Example
host1(config)# interface fastEthernet 4/1
•
Use the no version to remove IP from an interface or a subinterface. You must issue
the no version from the highest level down; you cannot remove an interface or a
subinterface if the one above it still exists.
•
See interface fastEthernet.
interface gigabitEthernet
interface tenGigabitEthernet
•
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
•
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models, and ERX310
router, use the
slot / port [. subinterface ] format.
•
To specify a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface for E120 and
E320 routers, use the
slot / adapter / port [. subinterface ] format.
•
For more information, see chapter Configuring Ethernet Interfaces in JunosE Physical
Layer Configuration Guide .
•
Examples
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 4/0/1
host1(config)# interface tenGigabitEthernet 4/0/1
•
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
•
See interface gigabitEthernet.
•
See interface tenGigabitEthernet.
ip address
Copyright © 2010, Juniper Networks, Inc. 542
JunosE 11.2.x Link Layer Configuration Guide