Juniper JUNOSE 11.2, Руководство по настройке

Страница: 82 / 772

host1(config-subif-atm-vc)# oam ais-rdi 5 10
host1(config-subif-atm-vc)# exit
•
Use the no version to restore the default values for the alarm down count and alarm
clear timeout duration.
•
See oam ais-rdi.
oam cc
•
Use to enable F5 OAM CC verification on an ATM data PVC.
•
You can optionally specify one of the following values to configure CC cell flows:
•
segment —Opens an F5 OAM CC segment cell flow
•
end-to-end —Opens an F5 OAM CC end-to-end cell flow
•
You must specify one of the following values to enable CC verification:
•
source —Enables this VC as the source point (cell generator)
•
sink —Enables this VC as a sink point (cell receiver)
•
both —Enables this VC as both a sink point and a source point
•
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
•
Example 1—Enables CC verification with a source endpoint
host1(config-subif-atm-vc)# oam cc source
host1(config-subif-atm-vc)# exit
•
Example 2—Opens an F5 OAM CC segment cell flow and enables CC verification with
a sink endpoint
host1(config-subif-atm-vc)# oam cc segment sink
host1(config-subif-atm-vc)# exit
•
Use the no version to disable F5 OAM CC verification and restore the default setting
for cell termination, end-to-end .
•
See oam cc.
oam-pvc
•
Use to enable generation of F5 OAM loopback cells on an ATM data PVC and, optionally,
enable F5 OAM VC integrity features on the circuit.
•
Use this command only on data PVCs configured with aal5snap , aal5autoconfig , or
aal5 mux ip encapsulation; the command is not valid for data PVCs configured with
other encapsulation types.
•
To enable F5 OAM VC integrity on the PVC, use the manage keyword.
•
You can optionally specify the number of seconds, in the range 1–600, for the router
to wait between the transmission of loopback cells during normal operation; the default
value is 10.
Copyright © 2010, Juniper Networks, Inc. 50
JunosE 11.2.x Link Layer Configuration Guide