Juniper JUNOSE 11.2, Руководство по настройке

Страница: 575 / 772

•
Use to assign an IP address and subnet mask to an interface or a subinterface.
•
Example
host1(config-if)# ip address 192.1.1.1 255.255.255.0
•
Use the no version to remove an IP address or disable IP processing.
•
See ip address.
pppoe auto-configure
•
Use to set up the router to dynamically create PPPoE subinterfaces on the PPPoE
major interfaces.
•
Example
host1(config-subif)# pppoe auto-configure
•
Use the no version to remove this configuration.
•
See pppoe auto-configure.
pppoe profile
•
Use to assign a profile to a static PPPoE major interface. The profile configuration is
used to dynamically configure an upper bridged Ethernet, IP, PPP, or PPPoE interface.
•
Specify a profile name with up to 80 alphanumeric characters.
•
The default encapsulation type, any , applies to any autoconfigured encapsulation that
does not have a specific profile assignment.
•
Examples
host1(config-subif)# pppoe profile pppoeProfile4
host1(config-if)# pppoe profile any anyProfile
•
Use the no version to remove the profile assignment from the interface.
•
See pppoe profile.
svlan ethertype
•
Use to assign an Ethertype value for the S-VLAN subinterface.
•
Choose one of the following Ethertype values:
•
8100 —Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
•
9100 —Specifies Ethertype value 0x9100, which is the default
•
9200 —Specifies Ethertype value 0x9200
•
Use an Ethertype value that matches the Ethertype value set on the customer premises
equipment (CPE) to which your router connects.
•
Example
host1(config-if)# svlan ethertype 8100
543 Copyright © 2010, Juniper Networks, Inc.
Chapter 17: Configuring Dynamic Interfaces