Juniper JUNOSE 11.2, Руководство по настройке, Страница: 61 / 772

•
Use the no version to disable the traps.
•
See atm snmp trap link-status.
atm sonet stm-1
Use to set the mode of operation on the physical interface to Synchronous Digital
Hierarchy (SDH) Synchronous Transport Mode (STM).
•
host1(config-if)# atm sonet stm-1
•
Use the no version to restore the default value, SONET STS-3c operation.
•
See atm sonet stm-1.
atm uni-version
•
Use to specify the UNI version for the interface to use.
•
Valid values are 3.0, 3.1, or 4.0.
•
Example
host1(config-if)# atm uni-version 4.0
•
There is no no version.
•
See atm uni-version.
atm vc-per-vp
•
Use to configure the number of VCs for each VP. The router does not execute this
command when any VCs are open on the interface.
•
VCs and VP tunnels must not exist when you issue this command. If they do, you must
delete the VC and VP tunnel configuration before you issue this command.
•
The specified value must be a power of 2, or an error message is returned.
•
The minimum number of VCs per VP is 4096 for OCx/STMx ATM line modules. If you
enter a value that is below the minimum, the router uses the minimum value.
•
The E120 and the E320 routers support the entire VPI/VCI range; therefore, it does not
support this command.
•
Example
host1(config-if)# atm vc-per-vp 128
•
Use the no version to restore the default value.
•
See atm vc-per-vp.
atm vp-tunnel
•
Use to define a VP tunnel and configure the rate of traffic flow within the tunnel.
•
You specify a tunnel rate in Kbps. All circuits in the VP are restricted to the rate that
you set.
•
The tunnel rate can be a value in the range 0–4294967295, when you specify the rate
of traffic flow without the constant bit rate (CBR) service category, and can be a value
29 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring ATM