Juniper JUNOSE 11.2, Руководство по настройке

Страница: 568 / 772

interface loopback
•
Use to access and configure the loopback interface.
•
Provides a stable address to minimize impact of a physical interface going down.
•
Example
host1(config)# interface loopback 20
host1(config-if)# ip address 10.10.20.5 255.255.255.254
•
Use the no version to delete the loopback interface.
•
See interface loopback.
ip address
•
Use to assign an IP address and subnet mask to a subinterface.
•
Example
host1(config-if)# ip address 10.10.20.5 255.255.255.254
•
Use the no version to remove an IP address or to disable IP processing.
•
See ip address.
ip unnumbered
•
Use to specify the numbered interface with which dynamic unnumbered interfaces
created with the profile are associated.
•
You can specify an unnumbered interface using RADIUS instead of using the ip
unnumbered command in a profile. For more information about how to specify an
unnumbered interface using RADIUS, see Configuring RADIUS Attributes in the JunosE
Broadband Access Configuration Guide .
•
Example
host1(config-profile)# ip unnumbered fastEthernet 0/0
•
Use the no version to remove the assignment from the profile.
•
See ip unnumbered
ip virtual-router
•
Use to assign a virtual router to a profile.
•
You can configure a virtual router using RADIUS instead of adding one to the profile
by using the
ip virtual-router command. For more information about how to configure
a virtual router using RADIUS, see Configuring RADIUS Attributes in the JunosE Broadband
Access Configuration Guide .
•
Example
host1(config-profile)# ip virtual-router VR1
•
Use the no version to remove the virtual router assignment.
•
See ip virtual-router
Copyright © 2010, Juniper Networks, Inc. 536
JunosE 11.2.x Link Layer Configuration Guide