Juniper JUNOSE 11.2, Руководство по настройке

Страница: 537 / 772

For ERX7xx models, ERX14xx models, and ERX310 router, use the slot / port format. For
example, the following command specifies a POS interface on slot 0, port 1 of an ERX7xx
model, ERX14xx model, or ERX310 router.
host1(config)# interface pos 0/1
For E120 and E320 routers, use the slot / adapter / port format, which includes an identifier
for the bay in which the I/O adapter (IOA) resides. In the software, adapter 0 identifies
the right IOA bay (E120 router) and the upper IOA bay (E320 router); adapter 1 identifies
the left IOA bay (E120 router) and the lower IOA bay (E320 router). For example, the
following command specifies a POS interface on slot 5, adapter 0, port 0 of an E320
router.
host1(config)# interface pos 5/0/0
For more information about supported interface types and specifiers on E Series routers,
see Interface Types and Specifiers in
JunosE Command Reference Guide .
Before You Configure Cisco HDLC
Before you configure a Cisco HDLC interface, you need to configure the physical interface
over which Cisco HDLC traffic flows, described in the following chapters:
• Configuring Channelized T3 Interfaces in JunosE Physical Layer Configuration Guide
•
Configuring T3 and E3 Interfaces in JunosE Physical Layer Configuration Guide
The procedures described in this chapter assume that a physical interface has been
configured.
Configuration Tasks
To configure a Cisco HDLC interface:
1.
Configure the physical interface on which you want to configure Cisco HDLC.
host1(config)# interface serial 3/1:2/1
2.
Select Cisco HDLC as the encapsulation method for the interface.
host1(config-if)# encapsulation hdlc
3.
Assign a local IP address to the interface.
host1(config-subif)# ip address 192.32.10.2 255.255.255.0
4.
(Optional) Use the appropriate “show hdlc interface” on page 509 to verify that the
configuration changes are correct.
encapsulation hdlc
•
Use to specify Cisco HDLC as the encapsulation method for the interface.
•
Example
host1(config-if)# encapsulation hdlc
505 Copyright © 2010, Juniper Networks, Inc.
Chapter 16: Configuring Cisco HDLC