Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010, Руководство по настройке

Страница: 122 / 794

For more information, see “Configuring SNMP Traps” on page 37.
Using VSAs for Dynamic IP Interfaces
Table 6 on page 82 describes the VSAs that apply to dynamic IP interfaces and are
supported on a per-user basis from RADIUS. For details, see
JUNOSe Link Layer
Configuration Guide .
Table 6: VSAs That Apply to Dynamic IP Interfaces
Value
Subtype
Length
Subtype Length Type Description VSA
string:
input-policy-name
sublen 10 len 26 Specifies
the name of
the input
(ingress)
policy Ingress-Policy-Name
string:
output-policy-name
sublen 11 len 26 Specifies
the name of
the output
(egress)
policy Egress-Policy-Name
integer: 0 –
disable, 1 – enable 6 12 12 26 Indicates
whether
statistics are
collected on
input Ingress-Statistics
integer: 0 –
disable, 1 – enable 6 13 12 26 Indicates
whether
statistics are
collected on
output Egress-Statistics
string:
qos-profile-name
sublen 26 len 26 Specifies
the name of
the QoS
profile to
attach to
the
interface QoS-Profile-Name
To use the VSAs shown in Table 6 on page 82:
■
Specify the policy, or one or more QoS VSAs in the desired RADIUS user entries.
■
Create the ingress or egress policy, or the QoS profile. Policies minimally consist
of one or more policy commands and may include classifier control lists and
rate limit profiles. See the
JUNOSe Policy Management Configuration Guide for
more information about policies and policy routing. See the JUNOSe Quality of
Service Configuration Guide for information about creating QoS profiles.
82 ■
Using VSAs for Dynamic IP Interfaces
JUNOSe 11.1.x Broadband Access Configuration Guide