Juniper IGP - CONFIGURATION GUIDE V11.1.X, Руководство по настройке

Страница: 252 / 454

host1(config-router-rn)# exit-remote-neighbor
■
There is no no version.
■
See exit-remote-neighbor
receive version
■
Use to restrict the RIP version that the router can receive on a RIP
remote-neighbor interface. The default is to receive both RIPv1 and RIPv2.
■
The off keyword overrides any other specified option; for example, configuring
both 1 and off or both 2 and off has the same result as configuring only off .
■
Example
host1(config-router-rn)# receive version 1
■
Use the no version to restore the default value, 1 2.
■
See receive version
remote-neighbor
■
Use to configure a RIP remote neighbor.
■
Example
host1(config-router)# remote-neighbor 10.25.100.14
■
Use the no version to remove the remote neighbor and any attributes configured
for the remote neighbor.
■
See remote-neighbor
send version
■
Use to restrict the RIP version that the router can send on an interface. The
default is to send only RIPv1.
■
Example
host1(config-router-rn)# send version 1
■
Use the no version to restore the default value, 1.
■
See send version
split-horizon
■
Use to configure the split horizon and poison reverse features for RIP remote
neighbors.
■
Split horizon is enabled by default; poison reverse routing updates are disabled
by default.
■
Poison reverse routing updates set the metric for routes originating on the
interface to infinity, thus explicitly advertising that the network is not reachable.
This helps to prevent routing loops.
228 ■
Remote Neighbors
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide