Juniper IGP - CONFIGURATION GUIDE V11.1.X, Руководство по настройке

Страница: 251 / 454

authentication-key
■
Use to specify the password for text authentication and the key for MD5
authentication for RIP remote-neighbor interface.
■
This command is supported only in RIPv2. Authentication is disabled by default.
■
Example
host1(config-router-rn)# authentication key 0 jun27ior
■
Use the no version to clear the key for the remote-neighbor interface.
■
See authentication-key
authentication mode
■
Use to specify the authentication mode for the remote neighbor interface.
■
Specify text to send a simple text password to remote neighbors. If a remote
neighbor does not have the same password, requests and updates from this
router are rejected.
■
Specify md5 keyID to send an MD5 hash to remote neighbors. Remote neighbors
must share the MD5 key to decrypt the message and encrypt the response.
■
This command is supported only in RIPv2. Authentication is disabled by default.
■
Example
host1(config-router-rn)# authentication mode text
■
Use the no version to remove authentication from the RIP remote-neighbor
interface.
■
See authentication mode
distribute-list
■
Use to apply a specific access list to either incoming or outgoing RIP route updates
on the RIP remote-neighbor interface.
■
An IP access list acts as a filter. Refer to access-list in the JUNOSe Command
Reference Guide for more information.
■
Example
host1(config)# distribute-list 5 in
■
Use the no version to stop application of the distribute list.
■
See distribute-list
exit-remote-neighbor
■
Use to exit from the Remote Neighbor Configuration mode and return to Router
Configuration mode.
■
Example
Remote Neighbors
■ 227
Chapter 4: Configuring RIP