Juniper IGP - CONFIGURATION GUIDE V11.1.X, Руководство по настройке

Страница: 284 / 454

■
Example
host1(config-router)# address 192.168.100.20 area 5
host1(config-router)# address 192.168.100.20 passive-interface
■
Use the no version to reenable the transmission of routing updates.
■
See address passive-interface
address priority
■
Use to specify the router priority, an 8-bit number in the range 1–255. Used in
determining the designated router for the particular network.
■
Applies only to nonbroadcast multiaccess (NBMA) networks. Every broadcast
and NBMA network has a designated router.
■
The interface can have an IP address, or it can be unnumbered.
■
Example
host1(config-router)# address unnumbered loopback 0 area 6
host1(config-router)# address unnumbered loopback 0 priority
■
Use the no version to restore the default value, 1.
■
See address priority
address retransmit-interval
■
Use to specify the time between LSA retransmissions for the interface when an
acknowledgment for the LSA is not received.
■
Specify an interval in the range 0–3600 seconds; the default value is 5.
■
The interface can have an IP address, or it can be unnumbered.
■
Example
host1(config-router)# address 192.168.10.200 area 6
host1(config-router)# address 192.168.10.200 retransmit-interval 500
■
Use the no version to restore the default value, 5 seconds.
■
See address retransmit-interval
address transmit-delay
■
Use to specify the estimated time it takes to transmit a link-state update packet
on the interface.
■
Specify an interval in the range 0–3600 seconds; the default value is 1.
■
The interface can have an IP address, or it can be unnumbered.
■
Example
host1(config-router)# address 10.100.25.38 area 7
host1(config-router)# address 10.100.25.38 transmit-delay 30
260 ■
Configuring OSPF Interfaces
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide