Juniper IGP - CONFIGURATION GUIDE V11.1.X, Руководство по настройке

Страница: 122 / 454

router will send and receive version 2 only. The default is configured for
RIP1.
■
Update interval—Current setting of the update timer (in seconds)
■
Invalid after—Current setting of the invalid timer (in seconds)
■
hold down time—Current setting of the hold down timer (in seconds)
■
flushed interval—Current setting of the flush timer (in seconds)
■
Filter applied to outgoing route update—Access list applied to outgoing
RIP route updates
■
Filter applied to incoming route update—Access list applied to incoming
RIP route updates
■
Global route map—Route map that specifies all RIP interfaces on the
router
■
Distance—Value added to RIP routes added to the IP routing table; the
default is 120.
■
Interface—Interface type on which RIP protocol is running
■
Redistributing—Protocol to which RIP is redistributing routes
■
Routing for Networks—Network for which RIP is currently injecting
routes
■
Example
host1# show ip protocols
Routing Protocol is “ bgp 100”
Redistributing: ospf
Default local preference is 100
IGP synchronization is enabled
Always compare MED is disabled
Router flap damping is disabled
Administrative Distance: external 20 internal 200 local 200
Neighbor(s):
Address 1.1.1.1
Outgoing update distribute list is 2
Outgoing update prefix list is efg
Incoming update prefix tree is abc
Incoming update filter list is 1
Routing for Networks:
192.168.1.0/24
Routing Protocol is “ isis isisOne”
System Id: 0000.0000.0011.00 IS-Type: level-1-2
Distance: 115
Address Summarization:
None
Routing for Networks:
fastEthernet0/0
Routing Protocol is “ ospf 1” with Router ID 192.168.1.151
Distance is 110
98 ■
Monitoring IP
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide