Juniper IGP - CONFIGURATION GUIDE V11.1.X, Руководство по настройке

Страница: 318 / 454

host1(config-router-rn)# authentication-none
■
There is no no version.
■
See authentication-none
cost
■
Use to specify a cost metric for the OSPF remote-neighbor interface; the metric
is used in the calculation of the SPF routing table.
■
The default value is 10 if there is no route to the remote neighbor; otherwise,
the default is calculated based on the bandwidth of the physical interface used
to reach the remote neighbor and the OSPF autocost reference bandwidth.
■
Example
host1(config-router-rn)# cost 235
■
Use the no version to restore the default value.
■
See cost
dead-interval
■
Use to set the time period, in seconds, that the OSPF router waits without
receiving hello packets from a remote neighbor before declaring the neighbor
to be down.
■
Example
host1(config-router-rn)# dead-interval 180
■
Use the no version to restore the default value, 40 seconds.
■
See dead-interval
hello-interval
■
Use to set the time interval between hello packets that the router sends on the
OSPF remote-neighbor interface.
■
Specify a value in the range 1–65535 seconds; the default value is 40 seconds.
■
Example
host1(config-router-rn)# hello-interval 15
■
Use the no version to restore the default value, 40 seconds.
■
See hello-interval
message-digest-key md5
■
Use to enable MD5 authentication for the OSPF remote-neighbor interface and
configure the MD5 key.
■
If you delete all MD5 keys, MD5 authentication is still enabled; you must either
configure an MD5 key or disable MD5 authentication with the
authentication-none command.
294 ■
Remote Neighbors
JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide