P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
6 - 2
Section 6
VEGA-RC™BankNote Recycler
Performance Tests
Display and Operation
The VEGA-RC DIP Switch and Pushbuttons are
used during VEGA-RC performance testing. Refer
to “Component Names” on page 1-4 of this Man-
ual to identify the location of these controls.
When running a Performance Test, the status and
test results of each test are indicated on the Seven
(7) Segment Displays located on the VEGA-RC
CPU Board visible through the Case Cover.
Refer to Figure 6-3 below as a guide for number
and character recognition when reading the Seven
(7) Segment Displays. Refer to “Component
Names” on page 1-4 of Section 1 of this Manual
for explanations defining the use of the four (4)
External Pushbutton Keys located on the left side
of the VEGA-RC Cabinet.
Performance Test Modes
To launch a particular Performance Test Mode,
proceed as follows:
1. Set DIP Switch No.8 of the VEGA-RC ON.
2. Apply power to the VEGA RC by turning the
VEGA Unit’s power ON. The VEGA-RC Unit is
now in Test Mode. The Seven (7) Segment Dis-
play will indicate “
T0
” to begin the Performance
Test Modes.
3. Figure 6-4 illustrates the nine (9) Seven (7) Seg-
ment Display patterns that occur during the vari-
ous Performance Tests selections.
4. Use Pushbuttons “B” or “D” to select a particular
Performance Test. When the desired Test number
is shown on the Seven (7) Segment Display, press
the “
A
” (
Change Display
) to start the selected
Test.
Test T0 - Key Function Test
This test group checks various Key functions of the
VEGA RC unit including:
•
Pushbutton Function Test
Figure 6-3
The 7 Segment Display Indications
NOTE: The “B” and “D” Pushbuttons are
used to select the individual Tests.
Pressing the “B” Pushbutton will select
the next higher numbered test. Pressing
the “D” Pushbutton will select the next
lower numbered test. When the 7
Segment Display indicates “T9”, it will
return to “T0” by pressing the “B”
(Dispense) Pushbutton again.
Figure 6-4
Performance Test Indication
T0: Key Function Test
T:1 Position Detection Sensor
1 A/D Value
T2: Position Detection Sensor
2 A/D Value
T3: Full/Empty Detection
Sensor 1 & 2 A/D Values
T:7 Communication Loop Test
T9: Detected dirt on the
Transport Belts
T4: Reserved
T5: Reserved
T6: Reserved
T8: Reserved
NOTE: Pressing the “A” Pushbutton for
more than 3 seconds will exit the current
Test and return to the Test Select Mode
with the 7-Segment Display showing “T0”.
