P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
4 - 4
Section 4
VEGA-RC™BankNote Recycler
Disassembly/Reassembly
4. While holding the Encoder Board in place,
remove its single (1) mounting screw
(See Figure 4-10 a), and lift the Encoder
Board up and off the Course Reversing
Assembly (See Figure 4-10 b).
5. Hold the RC Position Detection Board in
place and remove its single (1) mounting
screw (See Figure 4-10 c), then lift the RC
Position Detection Board up and off the
Course Reversing Assembly (See Figure 4-
10 d).
Rubber Pulley & Drive Roller
Removal
To remove the Rubber Pulley & Drive Roller
proceed as follows:
1. Remove the six (6) E-rings securing the
Drive Gear, Rollers and Bushings in place on
the Drive Shaft (See Figure 4-11 a
1
through
a
6
), and
2. Remove the three (3) Pins (See Figure 4-11
b
1,
b
2
& b
3
) from the Shaft, then
3. Separate the two (2) Rubber Rollers
(See Figure 4-11 c
1
& c
2
), the single (1)
Drive Roller (See Figure 4-11 d) from the
Shaft by pulling it out of the Assembly from
the right side (See Figure 4-11 e).
Clear & Metallic Edge Belt Removal
To remove the Clear & Metallic Edge Belt proceed
as follows:
1. Remove the three (3) End Cap retaining
screws (See Figure 4-12 a
1,
a
2
& a
3
) holding
the Tray Cover in place (See Figure 4-12 b),
and
2. Remove the Tray Cover from the VEGA-RC
Unit.
3. Loosen the two (2) Tray mounting screws
(See Figure 4-12 c
1
& c
2
) located on the left
and right sides of the Unit.
4. Using one hand, carefully flare/widen the
Plastic sides of the Unit at the top, and use
the other hand to pull the Tray outwards
from the Unit (See Figure 4-12 d).
5. With the Tray extended, remove the two (2)
Belts by sliding them off at the bottom left
and bottom right sides of the Tray.
NOTE: Be sure to hold onto the Circuit
Boards when removing their retaining
Screws in order to avoid damage to their
Sensors or other components located on
the Circuit Boards.
b
a
d
c
Figure 4-10
Encoder Board & Position Detection
Board Removal
d
e
a
1
a
2
a
3
a
4
a
5
a
6
b
1
b
2
b
3
c
1
c
2
Figure 4-11
Rubber and Drive Roller Removal
b
d
a
1
a
2
a
3
c
1
c
2
Figure 4-12
Tray Cover & Tray Removal
NOTE: Once the Clear, Transparent Film
Belts are removed from the Tray, manually
wind the Bobbins to remove any slack in
the Belts.