P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
6 - 1
S e c t i o n 6
6 PERFORMANCE TESTS
This section provides Performance Testing instruc-
tions for the VEGA-RC Banknote Recycler. This
section contains the following information:
•
Workbench Tool Requirements
•
Display and Operation
•
Performance Test Modes
Workbench Tool Requirements
The following tools are required to perform a
workbench software download:
•
VEGA-RC Unit
•
RC Maintenance Harness (JAC Part# 400-
100641R, EDP# 145994 [3371-05-001])
•
Power Supply (e.g., UAC, MIB232, etc.)
•
Harness (JAC Part# , EDP# [?]).
Figure 6-1 & Figure 6-2 provide illustrations for
connecting the Workbench Tools.
Figure 6-1
VEGA-RC Unit Test Connections
a
To VEGA-RC
c
b
To AC Power
Comm Connector
To Power
3rd pin & 4th pin
for Loop Test
Supply
a) VEGA-RC Unit
b) Harness
(Provide a loop connection between the 3rd and
4th pin to perform the Communication Loop Test)
c) Power Supply (e.g., UAC, MIB232, etc.).
NOTE: Only short the 3rd pin (TXD)
and the 4th pin (RXD) of the VEGA-RC
Main CPU Board CN3 to each other
when performing a Communication
Loop Test, otherwise leave them as
individual pin connections.
Figure 6-2
VEGA & VEGA-RC Test Connections
To VEGA-RC
Connector
e
To Interface
To AC
a
c
b
d
Comm
To VEGA
Comm
Connector
Connector
Power
To Power Supply
a) VEGA-RC Unit
b) VEGA Unit
c) Power Supply (e.g., UAC, MIB232, etc.)
d) Harness
e) VEGA to VEGA-RC Interconnection Harness
When preparing to run a VEGA-RC Unit
Performance Test, set DIP Switch No.8
on the VEGA RC Unit to 'ON'.
Although the two units are physically
connected, It is not necessary to set any
DIP Switches on the VEGA Unit in order
to run the VEGA-RC performance tests.
