P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
4 - 2
Section 4
VEGA-RC™BankNote Recycler
Disassembly/Reassembly
3. Remove the four (4) mounting screws (See
Figure 4-4 a
1
, a
2
, a
3
, & a
4
) from the bottom
base of the VEGA-RC Unit.
4. Release the Sensor Cable Harness from the
grooved Cable Channel located in the Base
(See Figure 4-4 b), and then separate the
Unit from the Base Assembly (See Figure 4-
4 c).
5. Remove the two (2) Gear Box Mounting
Screws (See Figure 4-5 a
1
& a
2
), and lift the
Gear Box Cover (See Figure 4-5 b) and
Motor (See Figure 4-5 c) out of the Base
Assembly.
6. Remove the two (2) Motor Mounting
Screws (4-5 d
1
& d
2
) retaining the Motor to
the Gear Box Cover, and pull the Motor out
of the Gear Box Cover Assembly.
NOTE: DO NOT OVER TIGHTEN the
Mounting Screws when replacing the
Right and Left Cover of the Unit! The
Plastic Screw Heads may be damaged,
making their future removal difficult.
c
b
a
1
a
2
a
3
a
4
Figure 4-3
Cover (R) & Cover (L) Removal
b
c
a
1
a
2
a
3
a
4
Figure 4-4
Base Part Removal
b
c
a
1
d
1
a
2
d
2
Figure 4-5
Motor Removal
NOTE: Ensure that the Motor Power Cable
feeds towards the front of the Base
Assembly when re-installing the Motor,
and that the Sensor Cables are re-routed
into the grooved Cable Channel (Refer to
Figure 4-6 a) when re-attaching the Base
Assembly to the Unit.
a
Figure 4-6
Drive Motor Installation
