P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
2 - 8
Section 2
VEGA-RC™ BankNote Recycler Installation/Operation
Cleaning Procedure
Cleaning the Banknote Recycler’s Transport path
is very important. Adhering Iron powder or dirt on
the Recycler’s Sensors may cause poor
performance or errors. Perform a scheduled clean-
ing at least once a month to keep the Recycler
Transport path clean. Use a dry, soft, lint-free cloth
or a Cotton swab to wipe dirt and stains from the
Magnetic and Optical Sensors, Rollers and Belts.
If necessary, blow the inside of the Unit clean with
a compressed air jet to remove clinging foreign
objects.
Figure 2-26 illustrates the locations of all of the
Recycler’s Sensors, and Table 2-4 lists their iden-
tity and specific cleaning preference.
1. Open the Rear Cover and Clean the exposed
Rubber Roller and four (4) Optical Sensors
(See Figure 2-27),
2. Clean the Pinch Roller and four (4) Prisms
(See Figure 2-28).
Caution: Do not use alcohol, thinner or
citrus based products for cleaning any
surfaces.
Table 2-4
VEGA Sensor Locations
No.
Sensor
Cleaning Preference
a)
Position Detection Sensor 1
Wipe clean using a lint-free cloth
b)
Position Detection Sensor 2
Wipe clean using a lint-free cloth
c)
Open/Close Detection Sensor
Blow clean with compressed air spray
d)
Full/Empty Detection Sensor 1
Blow clean with compressed air spray
e)
Full/Empty Detection Sensor 2
Blow clean with compressed air spray
f)
Transport Encoder Sensor
Blow clean with compressed air spray
Figure 2-26
VEGA-RC Sensor Locations
d)
e)
b)
a)
c)
f)
Rubber
Roller
Optical
Sensors
Figure 2-27
Roller and Optical Sensor Locations
Prisms
Pinch
Roller
Figure 2-28
Pinch Roller and Prism Locations
