P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
4 - 5
Disassembly/Reassembly
VEGA-RC™BankNote Recycler
Section 4
6. Rotate the White-colored Thumb Handle
(See Figure 4-13 a) in a clockwise direction
to turn the Main Bobbin (See Figure 4-13 b)
until the Belt Retaining Clips appear
(See Figure 4-13 c
1
& c
2
).
7. Remove the two (2) Clips from the Main
Bobbin (See Figure 4-13 d
1
& d
2
).
8. Remove the single (1) Metallic Silver Edge
Coated Belt (See Figure 4-13 e) and the three
(3) Clear, Transparent Film Belts
(See Figure 4-13 f
1,
f
2
& f
3
) from the Upper
Frame Body Shaft Assembly (See Figure 4-
13 g) and from the Lower Frame Body Shaft
Assembly (See Figure 4-13 h).
9. Remove the two (2) E-rings (See Figure 4-13
4-13 i
1
& i
2
) from the ends both Upper and
Lower Frame Body Shaft Assembly, and
take the Frame Body Assemblies out of the
VEGA-RC Unit (See Figure 4-13 j).
10. Slide the Belt Bobbin (See Figure 4-14 a
1
&
a
2
) to the inside, and pull the single (1) pin
out of the Shaft (See Figure 4-14 b).
11. Separate the two (2) Belt Bobbins from each
other, and perform same procedure used for
removing the Upper and Lower Frame Body
Shaft Assemblies.
a
b
e
g
h
j
c
1
c
2
d
1
d
2
f
1
f
2
f
3
i
1
i
2
Figure 4-13
Frame Body Shaft Assy. Removal
b
a
1
a
2
b
a
1
a
2
Figure 4-14
Belt Bobbin Removal
NOTE: When reeling the Belts back onto
their Bobbins (See Figure 4-15 a), be sure
to rotate the Belts in the direction indicated
by the arrow printed on the Bobbin.
When re-installing the KS Limit Spring
(See Figure 4-15 b), insert one end of the
spring into the hole located on the right
side of the Belt Bobbin (See Figure 4-15
c), and insert the other end into the
notched tip of the Bobbin Core (See Figure
4-15 d). When installed correctly, the Belts
will automatically self-retract when gently
pulled on.
a
b
c
d
Figure 4-15
Frame Body Shaft & Limit Spring
