P/N 960-100190RA_Rev. A {EDP #148851}
© 2009, Japan CashMachine Co., Limited
4 - 3
Disassembly/Reassembly
VEGA-RC™BankNote Recycler
Section 4
Open/Close Detection Board
Removal
To remove the Open/Close Detection Board
proceed as follows:
1. Unplug the two (2) Signal Connectors
(See Figure 4-7 a
1
& a
2
) attached to the
Encoder and Position Detection Boards.
2. Remove the single (1) Sensor Bracket
Mounting Screw (See Figure 4-8 a) retaining
the Sensor Bracket to the VEGA-RC Unit
(See Figure 4-8 b), and remove the Sensor
Bracket from the Unit.
3. Remove the single (1) mounting screw (See
See Figure 4-8 c) retaining the Open/Close
Detection Board in place (See Figure 4-8 d)
on the Sensor Bracket, and remove the Open/
Close Detection Board from the Sensor
Bracket.
4. Unplug the single (1) Signal Connector
(See Figure 4-8 e) attached to the Open/
Close Detection Board Head.
Encoder & Position Detection
Board Removal
To remove the Encoder & Position Detection
Board proceed as follows:
1. Remove the two (2) side mounting screws
(See Figure 4-9 a
1
& a
2
) holding the Course
Reversing Assembly (Figure 4-9 b) in place.
Using one hand, slightly flare/widen the left
and right Plastic sides of the Unit.
2. Using the other hand, grasp the Course
Reversing Assembly at its center, and pull it
straight outwards from the Unit along with
the Belts (see Figure 4-9 b).
3. With the Belts extended, remove the Course
Reversing Assembly from within the Belts
by carefully sliding it out to the right (see
Figure 4-9 c).
NOTE: Be sure to remove the Connectors
by grasping on the Connector Plug itself!
Pulling on the harness may damage the
Cable or dislodge the pins from within
Connector.
a
1
a
2
Figure 4-7
Connector Removal
a
b
e
d
c
Figure 4-8
Open/Close Detection Board Removal
NOTE: Be sure to grasp the small Circuit
Boards by their sides when removing or
reinstalling the mounting Screws in order
to avoid damage to their Sensors or other
Circuit Board components.
b
c
a
1
a
2
Figure 4-9
Course Reversing Assembly Removal
NOTE: The Clear, Transparent Film Belts
are tensioned and will automatically self-
retract back towards their Bobbins. Once
the Course Reversing Assembly is
removed, manually turn the Bobbins if
necessary to take up any remaining slack
in the Belts.
