Installation and Programming Manual
Installation
35
The activation of each relay is signaled by the on-board LED ([D] for relay 1 and
[E] for relay 2).
If you intend installing this board, work carefully through the following steps.
1. Disconnect all sources of power to the control panel (Mains 230V a.c and
battery power).
2. Insert the plastic supports into their respective locations (
Table 4: Control
panels - description of parts, Z
) on the back of the metal enclosure.
3. Position the board holes [G] on the supports and push the board towards
the back of the enclosure until it locks into position.
4. Insert the cable [H] into the connector [C].
5. Connect the two free wires of the cable [H] to terminals 14 (OC1) and 15
(OC2) on the control panel motherboard. Ensure that OC1 and OC2 on the
control panel are appropriately connected to the connector [C].
6. Connect the cable [I] to the connector [B] and to the 2 free pins [J] of the
connector on the switching power-supply, as shown in the figure.
3-10-2
SmartLink/GWB
The metal enclosures of SmartLiving 1050L and 10100L control panels provide
housing for SmartLink/GWB accessory boards and the respective [email protected]
backup batteries.
For the technical features and functions provided by these boards, refer to
paragraph
3-1-7 Land-line connection (PSTN)
.
The SmartLink/GWB kit includes:
•
SmartLink/G board
•
GSM antenna with 3 meter cable
•
Screws and star washers
•
Plastic supports for box mounting
•
10 resistors @ 15K
W
1/4W
The picture opposite shows the SmartLink mounted inside its enclosure. If you
intend installing this board, work carefully through the following steps.
1. Disconnect all sources of power to the control panel (Mains 230V a.c and
battery power).
2. Insert the plastic supports into their respective locations (
Table 4: Control
panels - description of parts, C1
) on the back of the metal enclosure.
3.
Position the board holes [A] on the supports and push the board towards the back
of the enclosure until it locks into position.
4. Secure the screw and star washer in place [B].
5. Connect terminal “1” ([C] “PWR+”) to a “+AUX” terminal on the control
panel motherboard, and terminal “2” ([C] “PWR-”) to a “
” terminal on
the control panel motherboard.
6. Power up the control panel (reconnect Mains 230V a.c and battery power).
7. Locate the battery properly into its housing (
Table 4: Control panels - description
of parts, E1
) and connect the wires [D] (red-positive, black-negative).
H
I
J
I
H
B
C
A
B
C
A
A
D
Содержание GameOver SmartLiving 1050
Страница 99: ...Installation and Programming Manual 99 Notes...
