INIM GameOver SmartLiving 1050, Инструкция по установке и программированию

Страница: 26 / 100

26 Installation
Installation and Programming Manual
3-2-3
Installing nCode/G and
Concept/G keypads
1. Connecting the device to the system
2. Pull the connection wires through the wire entry [A].
3. Connect the cables to the connector on the keypad backplate [B]. If you
are using the connector provided with the KB100 kit [C], connect the wires
to the terminals, in accordance with the instructions described in paragraph
2-3-2 nCode/G and Concept/G Keypads , then insert the connector into the
guide [D] until it locks into place.
4. Using at least 2 screws, mount the bracket to the wall.
5. Using the back-locking grips, attach the keypad to the bracket (as shown in
figure [E].
6. Fasten the screw [F] (included) into the screw location [G], to secure the
keypad properly to the bracket.
3-2-4
Installing nBy/S readers
The wall-mount nBy/S reader is suitable for indoor and outdoor installation.
Insert the two anchor screws [A] (included) into the two screw locations [B] on
the plastic backplate.
ATTENTION!
In order to avoid the risk of piercing the silicone seal [C], and thus jeopardizing
the waterproofing of the enclosure, insert the screws before fitting the seal.
3-2-5
Installing nBy/X readers
The Universal flush-mount nBy/X ( Patent Pending ) has been especially
designed to integrate with all brands of cover plates [A]. Drill two holes [B] for
the light guide [C].
Use the adhesive drill-pattern (see opposite) to mark the drilling locations
accurately.
B
C
D
A
E
G
F
C
A
B
A
B