INIM GameOver SmartLiving 1050, Инструкция по установке и программированию

Страница: 15 / 100

Installation and Programming Manual
The control panel and peripherals 15
You can connect Code/G and Concept/G keypads using the connector on the back
of the device, using either the 6 wire cable (included), or the KB100 terminal
board included in the deep-bracket kit (accessory kit).
2-3-3
Readers - nBy/S and nBy/X
Reader terminals:
Table 11: Connection cables - KB100 terminal board
n.
Wire
colour
KB100
terminal
board
description
1 Red + Wire/Terminal “ + ” for the I-BUS connection
2 Yellow D Wire/Terminal “ D ” for the I-BUS connection
3 Green S Wire/Terminal “ S ” for the I-BUS connection
4 Black - Wire/Terminal “ - ” for the I-BUS connection
5 Blue T1 Wire/terminal of keypad terminal T1
6 Black Negative power wire/terminal (Negative or GND)
Table 12: Brackets - Description of parts
I Wire entry
L Wall-mount screw locations
M Flush-mount screw locations
N Backlocking grips
6 wire cable KB100 - terminal board
I
L
Mounting bracket
L
M M
M
M
N
N
N
N
N
KB100 - deep mounting
bracket
I
L
L
M M
M
M
N
N
N
N
N
L
L
A
B
C
D
E
nBy/S
1 2 3 4
nBy/X
D
C
A
1 2 3 4
Table 13: Device Specifications
nBy/S nBy/X
Voltage [V] 9 - 16
Typical current draw [mA] 40 35
Dimensions (W x H x D) [mm] 64 x 80 x 17 19 x 50 x 51
Weight [g] 45 25
Table 14: nBy - Description of parts
A Terminal board
B Buzzer (nBy/S only)
C LED
D Antenna
E Optical sensors for open-enclosure and dislodgement tamper detection
Table 15: nBy - terminal board
n.
Icon/
Identifier
description
1 + Terminal “ + ” for the I-BUS connection
2 D Terminal “ D ” for the I-BUS connection
3 S Terminal “ S ” for the I-BUS connection
4 - Terminal “ - ” for the I-BUS connection
Patent pending