Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 108 / 357

108 Ethernet Port Configuration
Software Configuration Guide Release 2.10, Revision 1.00
This command can be used as soon as an encapsulation type is defined and the port was bound
successful to an IP interface.
Command Purpose
Step 1 node (cfg)#port ethernet slot port Enters Ethernet port configuration mode for the
interface on
slot and port
Step 2 node (prt-eth)[ slot / port ]#cos rx-
map layer 2 class of service value
as service class value
Adds a receive mapping table entry, which
converts a
layer 2 class of service into a service class
value
Example: Adding a Receive Mapping Table Entry
The following example shows how to add a receive mapping table entry, which converts a layer 2
class of service value of 2 into a service class value of 4 for the Ethernet port on slot 0
and port 0 of a
SmartNode 1000 or 2000 series device.
SN(cfg)# port ethernet 0 0
SN(prt-eth)[0/0]# cos rx-map 2 as 4
14.10 Adding a Transmit Mapping Table Entry
The transmit mapping table defines the conversion of transmitting SmartWare-specific service class
value into a Layer 2 CoS to service class value. Each conversion is stored as a mapping table entry.
Therefore the transmitting mapping table consists of several mapping table entries.
Procedure
To add a transmit mapping table entry
Mode
Configure
Command Purpose
Step 1 node (cfg)#port ethernet slot port
Enters Ethernet port configuration mode for the
interface on
slot and port
Step 2 node (prt-eth)[ slot / port ]#cos tx-
map service class value as layer 2
class of service value
Adds a transmit mapping table entry, which
converts a
service class value into a layer 2 class of
service
Example: Adding a Transmit Mapping Table Entry
The following example shows how to add a transmit mapping table entry, which converts a service
class value of 4 into a layer 2 class of service value of 2 for the Ethernet port on slot 0
and port 0 of a
SmartNode 1000 or 2000 series device.
SN(cfg)# port ethernet 0 0
SN(prt-eth)[0/0]# cos tx-map 4 as 2
14.11 Closing an Ethernet Port
An Ethernet port can be closed with the shutdown command. This command also disables and
closes the IP interface that is bound to that port. All static routing entries that are using this interface
change their state to ‘invalid’ and all dynamic routing entries will be removed from the route table
manager.