Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 207 / 357

PPP Configuration 207
Software Configuration Guide Release 2.10, Revision 1.00
SN(if-ip)[ppp_int~]# point-to-point
SN(if-ip)[ppp_int~]# ipaddress unnumbered
SN(if-ip)[ppp_int~]# tcp adjust-mss rx mtu
SN(if-ip)[ppp_int~]# tcp adjust-mss tx mtu
23.4 Creating a PPP Subscriber
One or more PPP subscriber shall be configured if either PPP peer requires authentication.
Procedure
To create a PPP subscriber
Mode
Configure
Command Purpose
Step 1 node (cfg) # subscriber ppp
name
Creates the new subscriber name , which contains
the authentication settings.
Step 2 node (subscr)[ name ]# dial
{in|out}
Defines the direction of the connection
establishment with PPP over ISDN. This
information allows to use different subscribers for
incoming and outgoing calls.
With the other two link layers, set the direction as
follows:
- PPP over Ethernet: ‘dial out’
- PPP over Serial: ‘dial in’
Step 3 node (subscr)[ name ]# [no]
authentication { (chap pap) |
{chap|pap} }
Defines the authentication protocol to be used,
PAP and/or CHAP
Step 4
(optional)
node (subscr)[ name ]# [no]
identification
{outbound|inbound} user
[password password ]
Sets the credentials to be provided during the
authentication procedure: the user name
user and
the password password .
The keywords ‘inbound’ and ‘outbound’ define
the direction of authentication:
- ‘inbound’: The local peer checks the credentials
that the remote peer sends.
- ‘outbound’: The local peer sends its credentials if
the remote peer requests them.
The following restrictions apply to the direction
of authentication:
- PPP over Ethernet: ‘outbound’ only
- PPP over Serial: ‘inbound only’
Step 5 node (subscr)[ name ]# [no] bind
interface interface [router]
Binds the subscriber to the IP interface to be used
for this PPP connection. The IP interface must
already exist and shall have the configuration as
outlined in the Section above.