Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 342 / 357

342 Appendix A
Software Configuration Guide Release 2.10, Revision 1.00
[no] priority
[no]
police <value> burst-size <option-value>
ic
voice <slot>
pcm {(law-select {aLaw | uLaw } ) }
status-request-timeout
{<timeout> | none }
exit
exit
profile_acl
[no]
profile acl <profile_name>
{permit|deny} {(ip {any | (host <src_ip> ) | (<src_ip> <src_wildcard> ) } {any | (host
<dst_ip> ) | (<dst_ip> <dst_wildcard> ) } ) | ({tcp|udp|sctp} {any | (host <src_ip> ) |
(<src_ip> <src_wildcard> ) } [eq <src_port> lt <src_port> gt <src_port> range
<src_port_from> <src_port_to> ] {any | (host <dst_ip> ) | (<dst_ip> <dst_wildcard> )
} [eq <dst_port> lt <dst_port> gt <dst_port> range <dst_port_from> <dst_port_to> ] )
| (icmp {any | (host <src_ip> ) | (<src_ip> <src_wildcard> ) } {any | (host <dst_ip> )
| (<dst_ip> <dst_wildcard> ) } [name {administratively-prohibited|alternate-
address|conversion-error|dod-host-prohibited|dod-net-prohibited|echo|echo-
reply|general-parameter-problem|host-isolated|host-precedence-unreachable|host-
redirect|host-tos-redirect|host-tos-unreachable|host-unknown|host-
unreachable|information-reply|information-request|mask-reply|mask-
request|mobile-redirect|net-redirect|net-tos-redirect|net-tos-unreachable|net-
unreachable|network-unknown|no-room-for-option|option-missing|packet-too-
big|parameter-problem|port-unreachable|precedence-unreachable|protocol-
unreachable|reassembly-timeout|redirect|router-advertisement|router-
solicitation|source-quench|source-route-failed|time-exceeded|timestamp-
reply|timestamp-request|traceroute|ttl-exceeded|unreachable} type <type> type
<type> code <code> ] ) } [[tos {max-reliability|max-throughput|min-delay|min-
monetary-cost|normal} ] [precedence {{critical|flash|flash-
override|immediate|internet|network|priority|routine} | <precedence> } ] dscp
<dscp> [mask {1|3|7|15|31} ] ] [cos <cos> cos-rtp <cos_rtp> <cos_rtcp> ]
exit
profile_service-policy
[no]
profile service-policy <arbiter-name>
mode {shaper | burst-shaper | wfq | burst-wfq }
[no]
rate-limit <value> [header-length <option-value> ]
[no] queue-limit <value>
[no] set ip dscp <value>
[no]
set ip precedence <value>
[no] set ip tos <value>
[no] set layer2 cos <value>
[no]
debug queue statistics [<value> ]
source
[no] source {(class <source-name> ) | (policy <source-name> ) }
rate
{<value> | remaining }
share <value>
[no]
random-detect [<value> ]