Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 148 / 357

148 Basic IP Routing Configuration
Procedure
To delete one or more static IP routes from the routing table
Mode
Administrator execution
Command Purpose
Step 1 node (cfg)#context ip router Enters the IP router context
Step 2 node (ctx-ip)[router]#no route network mask
{ address | interface }
Deletes a static route
For the syntax description see Chapter
, “Configuring Static IP Routes” above.
Example: Deleting a Static IP Route
In the following example, the route for packets to network 20.0.0.0/24, which are routed to device
with IP address 172.17.100.2, shall be deleted.
SN> enable
SN#
configure
SN(cfg)#
context ip router
SN(ctx-ip)[router]#
no route 20.0.0.0 255.255.255.0 172.17.100.2
17.5 Displaying IP Route Information
Procedure
To display static IP routes
Mode
Operator or administrator execution
Command Purpose
17.3
Step 1 node >show ip route Displays IP route information
This command displays the destination address, next-hop interface, protocol (local, static, rip, or
icmp), metric, flags (U up, H host, G Gateway, L local, D default), and amount of use for each route
in the routing table. If there are multiple routes to the same destination, the preferred route is
indicated by an asterisk (*).
Example: Displaying IP Route
In the following example, IP route information is displayed.
SN> show ip route
Routes of IP context 'router':
Status codes: * valid, U up, H host, G Gateway, L local, D default
Destination Nexthop Protocol Metric Flags Used
---------------------------------------------------------------------
* 127.0.0.1/32
local 0 LHG n/a
* 172.16.40.77/32 local 0 LHG n/a
* 172.17.100.210/32 local 0 LHG n/a
* 172.17.100.0/24 wan local 1 UL 0
* 20.0.0.0/24 172.17.100.2 static 0 U 0
* 172.16.0.0/16 lan local 1 UL 6
Software Configuration Guide Release 2.10, Revision 1.00