Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 37 / 357

Command Line Interface 37
In the operator exec mode,
nodename#
In the administrator exec mode and in the different configuration modes
nodename(mode)#
Where:
• nodename is the currently configured name of the node (SmartNode), the IP address or the
hardware type of the device that is being configured, and
• mode is a string indicating the current configuration mode, if applicable.
Example : the prompt in configuration mode , assuming the nodename SN is
SN(config)#
Table 5-1 shows the CLI commands used to enter each mode and the system prompt that is
displayed when you are working within each mode.
5.1.2 Navigating the CLI
Initial Mode
When you initiate a session you may login with either operator or administrator privileges.
Whichever login you use, on starting the CLI is always set to the operator exec (non-privileged exec)
mode by default. This mode allows you to examine the state of the system using a subset of the
available CLI commands.
System Changes
In order to make any changes to the system, the administrator exec (privileged exec) mode must be
entered. The
enable user interface command is used for this purpose. Once in administrator exec
mode, all of the system commands are available to you. The enable command is only accessible if
you are logged in as an administrator.
Configuration
To make configuration changes the configuration mode must be entered by using the configure
command in the administrator exec mode. From here the other configuration modes are accessible as
diagrammed in the overview in Figure 5-1.
Changing Modes
Within any configuration mode, the exit command brings the user up one level in the mode
hierarchy. For example, when in pvc configuration mode, typing exit will take you to framerelay
configuration mode.
The
exit command terminates a CLI session when typed from the operator exec mode.
A session can also be terminated using the logout command within any mode.
Mode Name Commands Used to Access Command-Line Prompt
operator exec (user log-on) node >
administrator exec enable command from operator exec
mode
node #
configure configure command from
administrator exec mode
node (config)#
system system command from configure
d
nod (sys)#
Software Configuration Guide Release 2.10, Revision 1.00