Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 284 / 357

284 POTS Port Configuration
Mode
Port PSTN
Command Purpose
Step 1 (config)#port pstn slot all Enter configuration mode for all POTS ports
Step 2 (prt-pstn)[ slot / port ]#use profile
pots profile
Select a profile containing the country specific
settings of the port attributes (ring voltage etc.).
The country settings are stored in a file which
comes together with the software for the IC-4ab.
The available country profiles are listed when
entering this command. The names listed are
composed as follows:
cfg< ISO3166-1-Alpha-2 2 digit country code>
Example:
cfgCH for Switzerland
cfgGB for Great Brittan
The default profile (not displayed in the list
when entering the command) is Switzerland.
29.5 POTS Port Configuration Task List
This chapter describes the steps for the configuration of a specific POTS port.
Procedure
Configure the POTS port parameters
Mode
Port PSTN
Command Purpose
Step 1 (config)#port pstn slot port
Enter POTS port configuration mode
Step 2 (prt-pstn)[ slot / port ]#caller-id 1
or
(prt-pstn)[ slot / port ]#caller-id pre-
ring
Caller-id (calling number) is sent to phone
(display) after first ringing.
Caller-id is sent to phone before ringing starts.
Step 3 (prt-pstn)[ slot / port ]#meter-pulses Enable the sending of meter pulses (tax pulses)
to the phone attached to this port
Step 4 (prt-pstn)[ slot / port ]#subscriber-
number number
Configure the subscriber number (MSN in ISDN
terms) of this analog phone
Software Configuration Guide Release 2.10, Revision 1.00