Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 238 / 357

238 CS Interface Configuration
Software Configuration Guide Release 2.10, Revision 1.00
dest-interface name
Step 7 node (ctx-cs)[ switch ]#no interface if-
type if-name
Delete an already defined interface.
Examples: Create an CS interfaces and delete another
The following example shows how to create and configure an interface, how to display it and how to
delete another.
SN>enable
SN#configure
SN(cfg)#context cs
SN(ctx-cs)[switch]#interface pstn PublicAccess
SN(if-pstn)[PublicA~]#routing dest-interface PBX
SN(if-pstn)[PublicA~]#interface pstn <?>
<name> Interface name
PBX Existing interface
PublicAccess Existing interface
PublicPSTN Existing interface
callapp Existing interface
SN(if-pstn)[PublicA~]#no interface pstn PublicPSTN
SN(ctx-cs)[switch]#interface pstn <?>
<name> Interface name
PBX Existing interface
PublicAccess Existing interface
callapp Existing interface
SN(ctx-cs)[switch]#
25.4 Configure Call Routing
SmartWare offers two levels of call routing, 'basic interface routing' and 'advanced session routing'.
Basic interface routing allows you to forward all incoming calls on a CS interface to a destination CS
interface. An optional fallback interface can also be specified.
Advanced session routing allows you to route calls to all available CS interfaces, based on a number
of criteria such as calling number, destination number, and ISDN bearer capability. Further the
Session Router also allows you to modify the calling and called party numbers in the call setup
messages.
In the environment of the CS interfaces, it is necessary to specify whether the call will be routed
directly to another CS interface ('basic interface routing') or to a first lookup table from the Session
Router (advanced session routing).
In this chapter only 'basic interface routing' is described. For configuration of 'advanced session
routing' refer to Chapter
26 , “ Session Router Configuration ”, which also describes the difference
between the two levels of call routing in more detail.
Procedure
To configure basic interface routing
Mode
Context CS
Command Purpose
Step 1 node (ctx-cs)[switch]#interface if-
type if-name
Enter CS Interface Configuration Mode and
configure interface
if-type with name if-name
Step 2 node (if -type )[ if-name ]#routing Specify a destination interface for incoming calls