Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 141 / 357

Serial Port Configuration 141
bind interface wan router
shutdown
exit
…
16.16 Displaying Frame Relay Information
Since Frame Relay configuration for the serial interface is complex and requires many commands, it
is helpful to list the frame relay configuration on screen.
Procedure
To display the Frame Relay configuration settings for the serial interface
Mode
Port serial
Command Purpose
Step 1 node (prt-ser)[ slot / port ]#show framerelay
Displays Frame Relay information
Example: Displaying Frame Relay Information
The following example displays the Frame Relay configuration settings for the serial interface.
SN(cfg)# port serial 0 0
SN(prt-ser)[0/0]# show framerelay
Framerelay Configuration:
Port
LMI-Type Keepalive Fragmentation
----------------------------------------------------------
serial 0 0 0
ansi 10 enabled
PVC Configuration:
Port
DLCI State Encaps Binding
----------------------------------------------------
serial 0 0 0
1 open rfc1490 wan@router
16.17 Examples
16.17.1 Displaying Serial Port Information
The following example shows the commands used to display serial port configuration settings for a
SmartNode 2300 series device. Moreover a typical command output is listed below.
SN> enable
SN# configure
1SN(cfg)# show port serial
Serial Interface Configuration
-------------------------------------
Port : serial 0 0 0
State : OPENED
Hardware Port : X.21
Port Type : DTE
CRC Type : CRC-16
Max Frame Length: 2048
Software Configuration Guide Release 2.10, Revision 1.00
Recv Threshold : 1
Encapsulation : framerelay