Inalp Networks SmartWare Release 2.10, Руководство по настройке программного обеспечения

Страница: 133 / 357

Serial Port Configuration 133
Software Configuration Guide Release 2.10, Revision 1.00
SN(cfg)# port serial 0 0
Step 3 node (prt-ser)[ slot / port ]#show port serial
Displays the serial interface
configuration.
Example: Configuring the Serial Encapsulation Type
The following example enables frame relay encapsulation for the serial interface on slot 0 and port 0
of a SmartNode 2300 series device. Check that in the command output of
show port serial
Encapsulation is set to framerelay .
SN(cfg)# port serial 0 0
SN(prt-ser)[0/0]# encapsulation framerelay
SN(prt-ser)[0/0]# show port serial
Serial Interface Configuration
------------------------------
Port : serial 0 0 0
State : CLOSED
Hardware Port : V.35
Transmit Edge : normal
Port Type : DTE
CRC Type : CRC-16
Max Frame Length: 2048
Recv Threshold
: 1
Encapsulation : framerelay
16.6 Configuring the Hardware Port Protocol
Before using the serial interface the hardware port protocol has to be specified. There are two
command options available to select the suitable hardware port protocol:
•
v35 for V.35 protocol to be used, or
• x21 for X.21 protocol to be used.
Procedure
To set the encapsulation type of the serial interface for frame relay
Mode
Administrator execution
Command Purpose
Step 1 node (cfg)#port serial slot port
Selects the serial interface on slot and
port
Step 2
node (prt-ser)[ slot / port ]#hardware-port
{v35 | x21}
Sets the hardware port protocol
Step 3 node (prt-ser)[ slot / port ]#show port serial Displays the serial interface
configuration
Example: Configuring the Hardw are Port Protocol
The following example enables X.21 as hardware port protocol for the serial interface on slot 0 and
port 0 of a SmartNode 2300 series device. Check that in the command output of
show port serial
Hardware Port is set to
X.21
.