IDT 89HPES16NT2, Руководство пользователя

Страница: 285 / 292

Notes
PES16NT2 User Manual 11 - 1 April 15, 2008
®
Chapter 11
Chapter 11
JTAG Boundary Scan
Introduction
The JTAG Boundary Scan interface provides a way to test the interconnections between integrated
circuit pins after they have been assembled onto a circuit board.
There are two pin types present in the PES16NT2: AC-coupled and DC-coupled (also called AC and DC
pins). The Boundary Scan interface in the PES16NT2 is IEEE 1149.1 compliant to allow testing of the DC
pins. The DC pins are those “normal” pins that do not require AC-coupling.
The presence of AC-coupling capacitors on some of the PES16NT2 pins prevents DC values from being
driven between a driver and receiver. An AC Boundary Scan methodology, as described in IEEE 1149.6, is
available to provide a time-varying signal to pass through the AC-coupling when in AC test mode; however,
IEEE 1149.6 is not supported in the PES16NT2.
Test Access Point
The system logic utilizes a 16-state, TAP controller, a six-bit instruction register, and five dedicated pins
to perform a variety of functions. The primary use of the JTAG TAP Controller state machine is to allow the
five external JTAG control pins to control and access the PES16NT2's many external signal pins. The JTAG
TAP Controller can also be used for identifying the device part number. The JTAG logic of the PES16NT2 is
depicted in Figure 11.1.
Figure 11.1 Diagram of the JTAG Logic
Refer to the IEEE 1149.1 document for an operational description of the Boundary Scan and TAP
controller.
Signal Definitions
JTAG operations such as reset, state-transition control, and clock sampling are handled through the
signals listed in Table 11.1. A functional overview of the TAP Controller and Boundary Scan registers is
provided in the sections following the table.
Bypass Register
Instruction Register Decoder
6-Bit Instruction Register
Tap Controller
m
u
x
m
u
x
Device ID Register
Boundary Scan Register
JTAG_TDI
JTAG_TMS
JTAG_TCK
JTAG_TRST_N
JTAG_TDO