IBM PC Server 325, Руководство пользователя

Страница: 175 / 288

Ethernet Controller Messages
PCNTNW-DOS-17 An invalid keyword was specified in NET.CFG on line xx.
Explanation: The keyword specified in the NET.CFG file is incorrect.
Action: Check the keyword in question. Make sure that the keyword is correctly
spelled.
PCNTNW-DOS-18 The frame type specified in the NET.CFG file is not supported.
Explanation: The NET.CFG file specified the PROTOCOL option for a PCNTNW
MLID. The specified frame type is not supported by the PCNTNW MLID.
Action:
Check the PROTOCOL line in the NET.CFG file for possible omissions of
required dashes and underscores, or any misspellings. Check the PCNTNW MLID
documentation for supported frame types.
PCNTNW-DOS-19 An invalid Ethernet node address is specified in NET.CFG. The
MLID modified the incorrect address bits.
Explanation: The NET.CFG file has an invalid node address. The PCNTNW MLID
modified and corrected the address.
Action: Verify the node address entries in the NET.CFG file.
PCNTNW-DOS-50 The board cannot be found.
Explanation: The Ethernet controller is either not configured correctly or is disabled.
Action: Perform the following steps:
1. Verify that the Ethernet jumper on the system board is set to the default, enabled
position.
2. Check the settings for the Ethernet controller (for example, the I/O and interrupt
request settings) against the settings in the NET.CFG. See “PCI Bus Control” on
page 33 for information on setting the interrupt requests.
3. If the problem persists, go to “About the Test Programs” on page 129 to run the
diagnostic utility.
PCNTNW-DOS-54 The board did not respond to the initialization command.
Explanation: The Ethernet controller initialization failed.
Action: Verify that the Ethernet jumper on the system board is set to the default,
enabled position. Go to “About the Test Programs” on page 129 to run the
diagnostic utility.
Chapter 4. Solving Problems
161