IBM PC Server 325, Руководство пользователя, Страница: 120 / 288

Installing the External SCSI Cable Connector
Installing the External SCSI Cable Connector
Before you begin
Ÿ Read “Electrical Safety” on page 53 and “Handling
Static-Sensitive Devices” on page 54.
Ÿ
Read the instructions that come with the option.
Ÿ Turn off the server.
Ÿ Disconnect all external cables and power cords, and then
remove the server cover (see “Preparing to Add Options” on
page 55).
Your server comes with a SCSI cable that you can use to connect
SCSI devices. You must remove the SCSI knockout on the rear of
the server; then, you can connect the cable from the SCSI connector
on the system board to the rear of the server.
Attention : After you install the SCSI cable, you must connect a
terminator or a properly terminated SCSI device to the external
connector.
In this procedure, you will remove the SCSI knockout panel. Two
narrow metal strips hold the panel in place.
To install the SCSI cable connector:
1. Locate the center of the SCSI knockout panel.
2. Use the screwdriver to carefully tap on the middle of the
knockout panel, near the bottom edge. The panel will bend
toward the interior of the server.
3. Working from the inside of the server, bend the knockout back
and forth several times, until it comes off.
4. Remove the screws from the connector end of the external SCSI
cable. Set the screws aside.
5. Insert the other end of the cable in the external SCSI connector
on the system board.
106
PC Server 325 User's Handbook