IBM P260, Инструкция по установке и обслуживанию

Страница: 117 / 524

Chapter 8. Troubleshooting
Use this information to diagnose and fix any problems that might occur in your compute node.
Introduction to problem solving
This problem determination and service information helps you solve problems that might occur in your
IBM Flex System Enterprise Chassis compute node. The information describes the diagnostic tools that
come with the compute node, error codes and suggested actions, and instructions for replacing failing
components.
Replaceable components are of three types:
v Tier 1 customer replaceable unit (CRU): Replacement of tier 1 CRUs is your responsibility. If IBM
installs a tier 1 CRU at your request, you are charged for the installation.
v Tier 2 customer replaceable unit: You can install a tier 2 CRU yourself or request IBM to install it, at
no additional charge, under the type of warranty service that is designated for your compute node.
v Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
The model number and serial number for the compute node are on the ID label on the bezel on the front
of the compute node, and on a label on the bottom of the compute node that is visible when the compute
node is not in the IBM Flex System Enterprise Chassis.
For information about the terms of the warranty and getting service and assistance, see the information
center or the Warranty and Support Information document on the IBM Flex System Enterprise Chassis
Documentation CD.
Solving problems
Use the diagnostic tools that are available to help you solve some common problems that might occur
while you are setting up the compute node.
About this task
If you install the compute node in the IBM Flex System Enterprise Chassis and the compute node does
not start, perform the following actions:
v
Make sure that the IBM Flex System Enterprise Chassis is correctly connected to a power source.
v Reseat the compute node in the IBM Flex System Enterprise Chassis, as described in “Installing the
compute node in an IBM Flex System Enterprise Chassis” on page 93.
v If the power-on LED is flashing slowly, turn on the compute node, as described in “Turning on the
compute node” on page 12.
v If you have just added a new optional device or component, make sure that it is correctly installed and
compatible with the compute node and its components. If the device or component is not compatible,
remove it from the compute node, reinstall the compute node in the IBM Flex System Enterprise
Chassis, and then restart the compute node.
If the compute node does not start after you have performed the preceding actions, see the online
information or the Problem Determination and Service Guide on the IBM Flex System Enterprise Chassis
Documentation CD.
© Copyright IBM Corp. 2012, 2015
105