IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 90 / 168

¹
Network Status
UP The network connection is established.
DOWN A network connection cannot be detected.
TESTING The router is attempting to determine if a
network connection exists.
UNKNOWN The state of a network connection cannot be
determined at this time.
N/A Network Status does not apply to this device.
Explanation of menu choices
While all of the menu choices are displayed for each device, only those
that are appropriate for the current state of the device will be active for a
selection.
Enable Device The device will be enabled for normal operation.
This performs the same function as the enable
or test commands available at the router’s
monitoring (talk 5) prompt (+).
Disable Device The device is taken out of its normal operational
state. If this menu option is available, then the
device must be disabled before any diagnostic
test can be started. This performs the same
function as the disable command available at
the router’s monitoring (talk 5) console.
Run Default Test This starts a test which assumes that the device
is set up for normal operation. For
communication adapters this means that it has
a cable attached and is connected to the
network.
Run Interactive Test This starts a test which will present an
additional menu of options such as cable
attachment and wrap plugs can be specified.
Stop Test Stops a looping test. Depending on the length
of each test loop, this could take up to a minute.
Loop Test - stop on first error
This starts a looping test that will stop when the
first error is detected. A menu of additional test
options may be presented before the loop is
started.
Loop Test - Log all errors
This starts a looping test that will loop until a
\"Stop Test\" request is made. All detected
errors are logged. A menu of additional test
options may be presented before the loop is
started.
View Test History Log Displays a history of recent diagnostic tests that
have been executed.
5-6
2216 Maintenance Manual