IBM Nways 2216, Руководство по обслуживанию и ремонту

Страница: 133 / 168

Suspend Traffic on an Adapter Port
Question How do I disable a configured adapter port to remove or test an
adapter?
Answer
1
Access the command line interface ( * prompt).
2
Type talk 5 and press Enter twice to reach the
+
prompt.
3
Enter the configuration command.
4
Make a note of the interface number of the adapter that you want
to disable.
5
Enter disable interface interface number.
Resume Traffic on an Adapter Port
Question How do I enable a configured adapter port (that was disabled using the
talk 5 disable command in “Suspend Traffic on an Adapter Port”) to
resume traffic?
Answer
1
Access the command line interface (
*
prompt).
2
Type talk 5 and press Enter twice to reach the + prompt.
3
Enter the configuration command.
4
Make a note of the interface number of the adapter you wish to
enable.
5
Enter test interface number.
Note: If you use the test command to enable an interface that
has been configured at the
Config> prompt (from talk 6) as
disabled, when you reboot the 2216 the interface will be disabled
again.
Therefore, you should also use the Config> enable interface
command to ensure that the interface is enabled the next time a
reboot does occur.
For details of this procedure, refer to the Multiprotocol Access Services
Software User’s Guide.
Appendix F. Common Tasks
F-7